I'm printing on an UMO with HBK, I wasn't talking about the elephant feet, but that the lines show and that you feel that some parts are not entirely flat. Given a print from @Korneel for example, that bottom was soooooo smooth.
Perhaps it's too much glue, or wrong glue?
Recommended Posts
cloakfiend 996
just print hot onto the glue/glass on your first layer. done. The 'elephant shoe' is good in my opinion because it guarantees a good stick and is very easy to sand off even if you are sticking two halfs together. Id steer clear from tape, it maybe flat but its not perfectly flat.
......if you are talking about the funny weird wrinkles that appear on the first layer, they usually go by the second, but i see you are using a UMO so i cant say anything on the matter, as i only used one once with a very bad experience and a failed 42 hour print.
Edited by GuestLink to post
Share on other sites