Hi Didier, I've not printed any thing really big, but I did try a simple sample tag only a few mm as shown below with the fan on 100% at 3rd layer with no problems.
Hi Jan, I did think about keeping it flat but I also wondered about a large flat piece were it may cause a higher pressure area on the workpiece as the air was restricted. At the moment they only approach the bed as a large square ish nozzle, if you want to try a flatter bottomed one I can model it for you :-)
- 1
Recommended Posts
Top Posters In This Topic
110
109
71
62
Popular Days
Aug 18
22
Feb 19
22
Feb 20
19
Jan 24
19
Top Posters In This Topic
swordriff 110 posts
gr5 109 posts
ultiarjan 71 posts
Anders Olsson 62 posts
Popular Days
Aug 18 2015
22 posts
Feb 19 2015
22 posts
Feb 20 2015
19 posts
Jan 24 2015
19 posts
Posted Images
ultiarjan 1,223
Like it, apart from the functionality it also just looks good.
Was just wondering (gut feeling) if the area marked in red is not too restricting for the airflow, I would compare it with something like the curve marked in green...
Link to post
Share on other sites