1 hour ago, GrillSgt said:@SandervG:
We are still using a software distribution tool to install Cura on the computers in our education department in our company. The installatoin is completly unattended. This has worked like a charm in the past. But 3.2 comes with "Arduino drivers". This Arduino drivers results in pop-up messages
It would be very nice to have an option (command line switch or something) to disable the installation of this drivers to prevent this pop-up. At the moment I don't see any possibility to decide which parts should be installed without the GUI.
Thanks
Michael
Just to be sure, you are using the /s (for silent) when installing?
Recommended Posts
kmanstudios 1,120
I think it is more fun to give half information and rant than be proactive like most people here are.
Link to post
Share on other sites
GrillSgt 0
@SandervG:
We are still using a software distribution tool to install Cura on the computers in our education department in our company. The installatoin is completly unattended. This has worked like a charm in the past. But 3.2 comes with "Arduino drivers". This Arduino drivers results in pop-up messages![image.png.41cecee458fdbb00ee79232e02716650.png](//content.invisioncic.com/ultimake/monthly_2018_02/image.png.41cecee458fdbb00ee79232e02716650.png)
It would be very nice to have an option (command line switch or something) to disable the installation of this drivers to prevent this pop-up. At the moment I don't see any possibility to decide which parts should be installed without the GUI.
Thanks
Michael
Link to post
Share on other sites