First of all, well done to DXU for making this possible.
Silly question here, I've noticed that both nozzles are never the same height which makes sense given you don't want to drag the second nozzle over the work of the first nozzle. Does the Z axis adjust for the different nozzle height? Also, when installing the heater blocks into the head should these be offset by a certain measurement? and if the Z axis adjusts for the different nozzle height where is this calibrated?
Apologies if this question has already been covered, thanks in advance.
Recommended Posts
klaasie 1
I followed the blog of burdickjp himself and that worked for me
Link to post
Share on other sites