Kevparang

You defiantly need spacers and since that are already like that, make sure to replace then, then you wont need to deal with them anymore. Just buy them from a trusted resource.

Also, when you take it into sunlight, after a while it will get yellowed.

You might also want to measure the PET with a caliper to make sure it is in the range of 2.8-2.9. If is not that might be why you are having issues with it.

You might need a higher hotend temperature because it might also be a little bit of underextrusion, leveling is important, and increase your hotend temp according to the middle of you filament specs.

Yes, I know that, it is like a battery.

What type of PLA do you use what are the specs? It really depends on that?Leveling would help. Try changing the build surface to just glue stick and glass.

Yes, but I would also recommend sdcard printing.

I also aim for 10 hours with a good fast speed.

Thanks.

May I ask why you are selling it?

Thanks.

@IRobertI you are correct, but I meant their is some user error with the paper.

I also have both installed and it really depends what you need the slicer for.

Thanks guys , it really helped.

I thought is was ABS, or something like PLA. A higher temperature will not really damage anything.

That depends if your how low your nozzle is.

Agreed, LePaul.

I think it also might be a look connect inside the nozzle, or of course agreed!!! This also might have other things to do, but to remove it you need to heat the hotend to around 150C and it will melt the plastic and use pliers or something to remove it.

I think it also might be a look connect inside the nozzle, or of course agreed!!!

I did not spam really, because they were inappropriate. Futhermore, this is a diffferent website and I have the right to keep it private now.

I think is should be able to grip, something like semiflex is a bit better, but some particles might let go into the water.

If he moves it too far leveling will be hard, you will need longer springs.Though you can change the offset and some settings in the software.

Here is a guide from simplifiy 3D You can look at. What is your bed and hotend temperature at. https://www.simplify3d.com/support/print-quality-troubleshooting/#layer-separation-and-splitting

AIR POWERED UMO3

I think people just buy a 2+.