40 minutes ago, tinkergnome said:
There should be a checkbox with the label "Enabled" somewhere...
I use the "Sidebar plugin" - so it may be in a different position than in my screenshot - but it is there.
If only one extruder is enabled (or present), Cura no longer adds tool change commands to the gcode and the pre-selected tool should just stay active.Personally I don't use Cura for single extrusion prints, but that's what i understood from the posts above? 🤷♂️
Yes I turned the extruder off and it still uses it. I then went to the machine settings and set the machine to only have 1 extruder and the same thing happens. I'm guessing I need to delete the code manually?
I've attached the code for your reference.
Recommended Posts
Top Posters In This Topic
90
81
72
66
Popular Days
May 5
30
Mar 24
25
May 4
23
May 6
22
Top Posters In This Topic
RudydG 90 posts
foehnsturm 81 posts
tinkergnome 72 posts
ultiarjan 66 posts
Popular Days
May 5 2017
30 posts
Mar 24 2020
25 posts
May 4 2017
23 posts
May 6 2017
22 posts
Popular Posts
rigs
@zerspaner_gerd & @MarcoUbtz Thank you gentlemen, everything is working perfectly now https://www.youmagine.com/designs/flexible-coupler-using-colorfabb-ngen-flex
zerspaner_gerd
Already found?? Here are my noted links: https://forum.simplify3d.com/viewtopic.php?f=8&t=1959
morfeushav
I am creating too a holder for mount the clamping dock on a ultimaker 2 aluminum clone. I haven´t have yet the final part., and I have to test it. This is how looks
Posted Images
navigator 24
That's what I do, as stated earlier - use standard UM2+ (Marlin flavour) for single head prints (Head 1 or 2 depending which head is mounted before starting print) and standard Mark2 profile for dual prints.
Only takes seconds to choose between them!
Link to post
Share on other sites