zerspaner_gerd 383
We haven't really looked into this, as travel moves are only a small part of the time spent on a single print. Doubling the speed of ~3% of the print will have a really big impact.
To the time savings I am not really, but is certainly a good side effect.
I am more concerned about the fact that with every travel paths some material Oozes out and that is extreme with Cura, because of the many unnecessary traverse paths, in addition comes that each time 70mm to 200mm distance is to be covered.
Have two attempts with Cura canceled since all the noses were, S3D has the same settings (Temp, Retract) printed immediately without problems. (Printed in XT-Colorfab)
Recommended Posts
Top Posters In This Topic
16
15
9
9
Popular Days
Jun 28
19
May 23
14
Jun 12
11
Jun 20
9
Top Posters In This Topic
nallath 16 posts
ahoeben 15 posts
LePaul 9 posts
kmanstudios 9 posts
Popular Days
Jun 28 2017
19 posts
May 23 2017
14 posts
Jun 12 2017
11 posts
Jun 20 2017
9 posts
Posted Images
Msuurmond 28
I just added a pull request for Uranium to implement this. It won't be in 2.6 (as that will go live tomorrow) but it will be in 2.7
Edited by GuestLink to post
Share on other sites