Hiya,
I never used the S3D bed levelling option. The machine's bed levelling works just well.
I would suggest just to use the that.
on a side note: I never use more that half the nozzle width as the layer height. By which I mean a 0.4mm nozzle I would never exceed layers of 0.2mm.
S3D's layer height I would use 100% or less. with a little extra extrusion multiplier so it squeezes more into the bed for adhesion.
hope this helps
Becky
Recommended Posts
neotko 1,417
https://ultimaker.com/en/community/16881-really-tiny-little-details-with-04-nozzle-s3d-umo
Link to post
Share on other sites