3 hours ago, viola0083 said:I'm desperate with this 5.2.8 firmware, please enlighten me how to restore to earlier version
I followed the instructions to recover from the link below. Need to create a recovery image on microSD and plug it in the processor board and let it boot up. Then power cycle and recalibrate the print head swap position. I haven't done it before and it was pretty straightforward.
Recommended Posts
itretail 5
Do Ultimaker actually monitor this forum, because as yet, no response whatsoever, despite all the issues mentioned here. I was considering ordering an S5 to get the bigger build space, but given their apparent complete lack of concern for customers i guess that is not going to happen now.
Link to post
Share on other sites