Hallo Michael
Dass sich XT nicht schlau kalt rausziehen lässt, habe ich leider auch schon festgestellt (ehrlich, ich habe keine Temperatur gefunden, wo es nicht reisst). Daher würde ich einfach mal versuchen, bei 240°C PLA durch die Düse zu drucken, am besten von Hand. Und dann den Cold pull ausführen. Wenn beim Durchdrücken nichts aus der Düse kommt, am besten mal mit einer feinen Nadel von unten gegenstechen (aufpassen - Verbrennungsgefahr, das PLA wird dann flüssig runtertropfen).
Die Alternative ist natürlich, eine neue 0.4mm Düse einzubauen.
Ist während des Drucks die Temperatur eigentlich stabil?