Thanks tinkergnome for the fast response
I did what you asked
I installed Tinker-MarlinUltimaker2extendedPlus-17.10.1 factory reset then did the buildplate calibration everything went normal i then installed Tinker-Mark2-extended-dual-17.09 ( i have the mark2 expansion board disconnected and connected the second head directly on the main board) i did NOT do a factory reset and checked all the prefereces settings but it looks normal. But when i choose raise buildplate in the display the buildplate raise very slooooooooow, like 1cm in 1 minute and when i choose to adjust nozzle (1) the head goes right in the wall and not stopping
Recommended Posts
Top Posters In This Topic
90
81
72
66
Popular Days
May 5
30
Mar 24
25
May 4
23
May 6
22
Top Posters In This Topic
RudydG 90 posts
foehnsturm 81 posts
tinkergnome 72 posts
ultiarjan 66 posts
Popular Days
May 5 2017
30 posts
Mar 24 2020
25 posts
May 4 2017
23 posts
May 6 2017
22 posts
Popular Posts
rigs
@zerspaner_gerd & @MarcoUbtz Thank you gentlemen, everything is working perfectly now https://www.youmagine.com/designs/flexible-coupler-using-colorfabb-ngen-flex
zerspaner_gerd
Already found?? Here are my noted links: https://forum.simplify3d.com/viewtopic.php?f=8&t=1959
morfeushav
I am creating too a holder for mount the clamping dock on a ultimaker 2 aluminum clone. I haven´t have yet the final part., and I have to test it. This is how looks
Posted Images
tinkergnome 927
Sounds weird...
If you're lucky, this are only some corrupted values in the EEPROM. You can try the following:
Link to post
Share on other sites